Anatomy: How to test the cooperation between the bearing and the shaft

Source: Bearing network time: 2013-04-19

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

Usually, the bearing force of the bearing bush is between 0. 02 and 0. 04 mm. If the pressing force does not meet the specifications, it can be adjusted by increasing or decreasing the thickness of the gasket at the joint surface of the bearing and the bearing seat; the back of the tile is not allowed to be padded.
When the clearance of the sliding bearing does not conform to the regulation; adjustment should be made. The split bearing is often used to adjust the radial clearance (top clearance).
In addition to ensuring radial clearance, the plain bearings should also ensure axial clearance. When detecting axial clearances; move the shaft to a pole orientation; then measure the axis from one pole to the other with a feeler gauge or dial indicator The amount of turbulence is the axial gap.
When testing; first open the bearing cover; use the appropriate diameter of the lead wire; cut it into 15~40 mm long section; place it on the journal and the upper and lower bearing interface; cover the bearing cover; tighten according to the regular torque Bolt; then loosen the bolt; remove the bearing cap; use a micrometer to detect the thickness of the flattened wire; find the average value of the bearing top clearance.
If the headspace is too. Slightly thin (11) å³¦å‘“å²· å«” å«” . .. If too large; then reduce the pad, scrape the ground or cast the tile from the head.
Adjustment of bearing bushing force: In order to avoid possible transition and axial movement of the bearing bush during operation; in addition to cooperating with interference and stopping parts; it is necessary to use bearing cap to compress; bearing method and measuring top gap method The same; the thickness of the soft lead wire is measured; the bearing bushing force can be calculated (indicated by the amount of elastic deformation after the bushing is tightened)
The cooperation gap between the bearing and the shaft is necessary; the following methods can be used to detect the radial clearance.
2, the lead detection method 1, the ruler detection method on the larger diameter bearing; the gap is larger; to use the narrow feeler gauge to directly detect. About the smaller diameter of the bearing; the gap is more than the æ§é˜Œ åŸé¥¬æµš åŸé¥¬æµšå²¢ ç‰Ÿå˜žå®æ§åŒ¦èƒ— ç‰Ÿå˜žå®æ§åŒ¦èƒ— ç©¸ ç©¸ ç©¸ é’¡ é’¡ é’¡ é’¡ é’¡.
The use of the pressure lead method to detect the bearing gap is more accurate than the feeler gauge; but it is more troublesome. The aluminum wire used for the test should be soft; the diameter should not be too large or too. Noisy this section of the pocket 1. 5~2 times; practice It is usually tested with soft lead wire.

Recommend to friends comments close window

Bearing related knowledge

Analysis: Reasons and conclusions of the overhaul of the air bearing head of the air compressor
The cause of failure of NTN bearing and the adoption method The characteristics and use of spindle bearing oil
NSK bearing function review double row angular touch ball bearing analysis and feature depiction

This article links to http://
Please indicate China Bearing Network http://

Previous:Discussion on the fundamental characteristics of thrust spherical roller Next:The reason for affecting SKF imported bearing grinding èœ•

Stainless Steel Faucet

Stainless Steel Faucet,Stainless Steel Kitchen Faucet,Stainless Steel Kitchen Tap,Stainless Faucet

Heshan Janno Kitchen and Bath Technology Co.,Ltd , https://www.janno-ks.com