Bathroom malfunction gas shower can not beat the fire how to do

When the weather is cold, water heaters are used more and more frequently in our daily lives, but gas showers often have problems with the use of fire in our use. Then we all know what to do if we can't get fire. Today is here. Tell everyone about what it can do if it doesn't catch fire, and hopefully it will help everyone.

What causes the gas shower to be out of flame? The gas water heater can't break the fire and it can be divided into non-ignition sounds, no ignition, and ignition sounds.

1, the battery problem: If you use the battery to first look at the battery is not too old, the voltage is not enough gas water heater will not be able to fire. Before confirming that the solenoid valve is good or bad, check whether the igniter control circuit is normal. If there is a fault, the solenoid valve cannot be controlled to close.

2. Ignition failure: One side of the pulse igniter and controller is faulty, and the gas water heater cannot be normally ignited.

3, water pressure problems: a. When the water pressure is low, the gas water heater cannot start normally and the fire cannot be achieved; b. The filter blockage at the water inlet causes the water to flow normally, and it can be cleaned.

4, water and gas linkage device failure: a. water vapor valve tympanic membrane aging or damage can not promote the micro switch; b. micro switch bad.

5. The air source switch is not open or the intake air filter is blocked. Open the air source correctly and clean the intake air filter.

6, gas does not match: For example, the liquefied gas water heater received natural gas superior.

7. After the valve seal is corroded by gas, it will rise. Replace parts.

8, smoke pipe can not be normal exhaust. a. There is a blockage in the pipe and the blockage of the pipe is cleaned; b. The pipe is too long and is not properly installed.

I believe that after reading the above, we should understand that the gas shower is not on fire and hope to help everyone.

Bathroom

Our company produces a vary of specifications of Glass Particles and glass-lumps which can be used in ordinary pavement of road to shorten braking distance effectively, to improve the warning role and to decelerate in advance to achieve safety. Pavement laid with this product will not peel off and maintain function well after a long time wheel friction. 
It is also used in the decoration of building outer-walls and all kinds of ceramic. There is mainly 1-2 mm, 2-3 mm, 3-4 mm, 600-850 microns, 300-600 microns, 180-300, and less than 180 microns etc. as well customized specifications customers require.

The glass bead can be produced based on the standard of countries or areas, such as EN1423/1424, AASHTO M247, BS6088, JIS R3301 and KS L2521 etc.

Glass Particles

Glass Particles

Glass Particles,Plastic Glass Particles,Color Fireproof Glass Particles,Crushed Colored Glass Particles

CHIYE GLASS BEAD (HEBEI) CO., LTD , https://www.chiyeglassbeads.com

Posted on