Buy environmental protection cabinets should be fully considered not only look at sheet environmental protection

As Golden Week approaches, and every decoration season, many consumers are considering what kind of cabinets they should buy. Yao Liangsong, chairman of Europa Cabinet Company, stated that green, environmental protection and health are undoubtedly the primary considerations for modern consumers when purchasing home products including cabinets. Therefore, Chairman Yao suggested that consumers should first choose “environmental cabinets”, and at the same time, introduce the issues that need attention in the purchase of “environmental cabinets”.

Yao Liangsong, chairman of the board, said that E0 sheet is indeed an environmentally friendly sheet, but sheet environmental protection does not mean that the cabinet is environmentally friendly.

Because the cabinet production is a systematic project, there are many factors in this process that will affect the environmental quality of the cabinet. Plates are just a kind of substrate used in the processing of cabinets. In the process of processing, a large amount of raw materials such as edge sealing glue, door panel baking paint, etc. must be used. Formaldehyde is widely used as a solvent in these raw materials. Even imported high-end edge adhesives and paints have formaldehyde release, not to mention low-quality raw materials. At the same time, besides the plates, the cabinets also have table tops, kick lines and other accessories. The environmental protection of these materials will also affect the environmental quality of the cabinets. Therefore, cabinets that do not use plates of the E0 environmental protection standard meet environmental standards.

Cabinets Purchase Formaldehyde Paint Europe School Home Furnishing Home Kitchen Doors Kitchen cabinet Door Decoration Home

Other Door Accessories

Sectional Door Accessories: motor 220V-380V, control box, spring break device, cable break device , aluminum alloy rope pulley, enhanced shaft bracket, air bag system, duplex enhanced guide wheel bracket.

Detail introduction for above main accessories

1.Motor and controller:

The garage door operator is designed for residential overhead sectional and tilt doors.

The operator memorizes the limit positions and unique braking system that slows the unit down at the end of its travel.

Rolling code remote control with max. 20 pcs hand transmitters.

The operator is equipped with a manual release lever which allows manual operation of the door in case of power failure.

The controller has a security LOCK function which prevents operation of the door from transmitter.

2.spring break device:

Sectional doors are hinged and they bend in the tracks as the door opens and closes. Many of these doors are counterbalanced with extension springs, also designated "stretch springs," and they have seven characteristics. The length is the measurement of all the coils pressed together. This, along with the inside diameter of the coils and wire size - the thickness of the wire from which the springs are made - determine the stretch, the distance the spring is extended - normally half the door height, and pull, the force the spring pulls when stretched its normal length. The type of ends determine how the ends of the spring are mounted. The initial tension is the percentage of pull needed to separate the coils. This is determined by the pitch with which the springs are wound. On sectional garage door springs this is normally 15 percent. For example a 100 pound pull spring requires 15 pounds of weight to separate the coils; when a door is open the two springs will support 15 pounds of door weight without any stretch.

Most extension springs are made of oil tempered wire. These are normally coated or painted. Some springs are made of galvanized wire.

3.able break device:

cable break device ,door hardware

adjustable bottom bracket .

the raw material hot plate

zinc plated

safety device

adjustable bottom bracket

the raw material hot plate

zinc plating

spring safety device ,2" and 3" safety device

once the cable is broken ,this devoice can keep the hurt away from the door falling

4.aluminum alloy rope pulley

Equipment: CNC stamping/punching machine, CNC bending machine, CNC cutting

machine, 5~250 tons punching machines, welding machine, polish machines...

Processed material: stainless steel: copper, carbon steel

Surface treatment: Hot galvanized, polishing

Making process:Stamping, deep drawing,bending, punching, laser cutting,threading,

welding, tapping, riveting, grinding

5.air bag system

It is a safety device. When the door is down to hit something, it will up automatically.

Operation pressure:<3mbar

Battery:CR2032*2

Battery lifetime>1 year

Emission frequency: 315MHZ

Emission power:<10mW

Receiver power source:12V

6.duplex enhanced guide wheel bracket

Determining the right type of sectional door roller for your garage door tracks can be a little confusing, especially when you do not know what you need to look for in a garage door roller. To simplify things, there are two primary things you need to be aware of. First are the actual dimensions of the roller, and second is purpose that you will be using the door for. You can read below about measuring your roller and choosing the right quality of material for your door.

Other Door Accessories,Electronic Door Accessories,Automatic Door Accessories,High Speed Door Radar Detector

Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hfautodoors.com

Posted on