![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
Did everyone encounter such a problem when washing their hands, that is, when the faucet was just unscrewed, the water flow was too small, and it was very anxious. So I asked a friend who knows how to do it. I thought about it when I wanted to solve the problem. Isn’t the pressure enough, and the water is not coming. Sometimes it's still intermittent. Then everyone will follow the Xiaobian together to see the wonderful content of how the faucet water flow is small .
First, the faucet maintenance methods
Unscrew the faucet filter counterclockwise. (If you can't screw it, the cloth is unscrewed with a nipper, and the cloth will prevent the filter from being damaged.) Figure 2 shows the unscrewed filter.
The filter mouth is down, and the top of the filter is pressed upwards to push the plastic filter element out. (Figure 2 is the disassembled filter and plastic filter)
Place the plastic filter element under the faucet, gently scrub with a toothbrush, and wash off a small layer of scale on top.
1. Assemble the cleaned filter and re-screw it onto the faucet. OK! Solve the problem in three easy steps.
(Different areas, different water quality, fine impurities in the water sometimes penetrate into the filter element, if the problem is not resolved, please refer to the following steps)
2. Lay the filter element flat with one end of the green filter screen up. Insert the small cutting tip into the side seam as shown in the figure to remove the green cone filter.
Hold the filter element, insert the small scissors into the rectangular hole with your right hand, and force the second layer of the filter cover upwards obliquely. The third and fourth layer-shaped gratings are then poured out. (Figure 1 shows the filter element after decomposition. Figure 2 shows the filter structure after complete decomposition)
Wash the components with a toothbrush.
The fourth and third-piece gratings and the second-layer disc-shaped filter cover are sequentially loaded into the filter element in the reverse order of decomposition, and finally the green cone-shaped filter screen is pressed into the filter card slot with a small shear.
Insert the combined filter element into the filter in the direction of the arrow. When installing, pay attention to the filter element should be flush with the filter to avoid poor installation when screwing into the faucet.
Screw the filter clockwise.
Open the faucet, is it like a stream of water!
Second, matters needing attention
The faucet is not used for a long time. Generally, there is no component failure. Most of them are caused by scale or other impurities. Especially the faucet that uses solar hot water is more likely to block in summer.
For better quality faucets, fine sand scales are mostly concentrated on the first layer of green cone filter screen. Just clean the layer filter, and the plastic filter element does not need to be disassembled and cleaned. If the diameter of the tapered filter is greater than 0.5mm, consider removing the plastic filter.
The structure of the faucet is much the same, more than tens of yuan, and the faucet filter mode within 100 yuan is mostly similar. Most of the tens of yuan or less are single-layer or composite filters, and the filter material is generally steel wire, alloy wire, chemical fiber or plastic. Most of the 20 yuan or less do not have a filter screen, and most of the faucet nozzles are equipped with a honeycomb filter, so you can use it with confidence!
How about, I saw the wonderful introduction to the faucet water flow. Have you learned a lot about the faucet water flow? I hope that you can learn more about home improvement knowledge through this article, and you will be able to create a more perfect home environment. Thank you for reading this article and your support and love for Xiaobian. If you want to get more information about home improvement, please continue to pay attention to the decoration home network.
Single Core Soldering Wire,Halogen Free Single Solder,Brightness Soldering Joint Welding Wire,Without Connection Machine Soldering Wire
NINGBO XIHAN TIN SOLDER CO.,LTD. , https://www.soldertop.com