![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
[Asia Pump Network News] wells with submersible pumps, also known as deep submersible pumps, since used in the underground, you have to go down the installation, so to speak is not so easy. Today, Xiaobian introduce wells to wells with submersible pumps installation method. Although the installation requires skilled skills, but we still can understand the next, maybe you can get. The details are as follows: Well submersible pump downhole installation method Well submersible pump downhole installation generally there are two ways: one is the low lift (generally less than 30m) submersible pump can be installed using the hose; and lift higher Usually more than 30m) submersible pump should be installed with steel pipe. 1, the use of hose to install the use of hose to install the submersible pump to go down, you can directly use wire rope or other can withstand submersible pumps and plumbing and the total weight of the rope (such as nylon rope, etc.) vertically lifted in the well. 2, the use of steel pipe down to install the use of steel pipe wells installed submersible pump, the installation method is as follows: 1) clamp with submarine well pump submersible pump pump the upper part of the submersible pump, and hoisted with a chain hoist and slowly into the well Until the clamp rests firmly on the wellhead, remove the chain. 2) Clamp a connecting pipe with another pair of clamps and lift it 15 cm away from the connecting pipe flange with a lifting chain and slowly lower it. Connect the rubber gasket between the connecting pipe flange and the submersible pump flange, tighten the connecting pipe flange and the submersible pump flange evenly with bolts, nuts and spring washers. 3) Slightly lift the submersible pump, remove the clamp at the upper end of the submersible pump and fasten the cable to the connecting pipe with a plastic tape or a cable card. Slowly lower the clamp so that the clamp rests firmly on the wellhead. 4) Use the same method to connect all the water pipes to the submersible pump for well use and into the well. 5) The well with the submersible pump leads the cable access control switch, and then access the three-phase power. Above is the well with submersible pump downhole installation method, from the introduction we know that there are two ways, including steel pipe downhole installation method is more complex, need more skills. When installing, you have to choose the appropriate method based on the specific situation (head), rather than arbitrary. Expand to read: Pumps Valves Tube Fittings Exhibition Water Expo Xiamen Maritime Exhibition Internet + Forum Yiwu Fair Mold Top Ten Brands 2016 Exhibition Information This article belongs to Industrial Internet (Xiamen) Technology Co., Ltd. All are welcome to reprint, please note Ming author and source of: Asian pumps network editor: small L (QQ / micro-channel:) starting: http: //beng.liuti.cn/ (service hotline:)
Carbon Steel Caps,Carbon Steel End Caps,Carbon Steel Pipe Caps,Carbon Steel Weld Caps
Cangzhou Youlong Pipe Fitting Manufacturing Co., LTD , https://www.ypco88.com